# Floor Edge Filler

Four 3/4 in plywood strips cut on the CNC that fill the gap at the edge of the van floor. A and C run the same way, B turns between them, and D stands off A like B. The 3D printing panel applies to the printed brackets only.

[Open the configurator](index.html) · status: **draft**, version 0.1

Strips of 3/4 in plywood fill the gap at the edge of the van floor. A runs along X, B turns 90 degrees at the end of A, C continues from the outer face of B, and D stands off A. Corners join with a rabbet and screws, a box joint, or printed brackets. Each piece is drawn flat in its own frame, so the same outlines feed the DXF for VCarve. The page opens in inches.

## Settings

Grouped as Pieces, Corners, Piece D, Storage opening in A, Slot in A, Notch in C, Stock and bit. Every length takes mm or inches; the model works in mm.

## Presets

- **Rabbet corners**: As measured. Pocket at each corner, screws.
- **Box joint corners**: As measured. Five fingers, 1/4 in bit.
- **Printed brackets**: As measured. Butt cuts, removable.

## Exports

**CNC outlines (DXF)** for VCarve, in inches, laid out on the sheet from the lower left corner: PROFILE holds the cut outlines, SHEET_OUTLINE shows the sheet edge, and each pocket gets a layer named for its piece, face and depth. The file opens with a `999` comment carrying the credit. STL and 3MF for the printed brackets come from the 3D printing panel.

## Files

    index.html    page shell; loads the shared kit from ../../kit/
    model.js      settings, presets and build(), the geometry engine of record (JS, manifold-3d)
    model.json    title, summary, visibility, version and changelog
    thumb.png     catalog card art

Needs a network connection: three.js loads from a CDN, as on every kit page.

## License

© Ryan Mitchell — CC BY 4.0. See [LICENSE.txt](../../LICENSE.txt).