# Slider Door Stop

A detent strip for the sliding door track. The roller climbs a ramp, drops into a curved cup and holds the door until you push it out.

[Open the configurator](index.html) · status: **draft**, version 0.1

Copied from the stamped metal detent strip in the Transit sliding door track. The roller climbs a ramp, drops into a curved cup and holds the door there until you push it out. The view shows the roller moving through the cup; a toggle hides it.

## Settings

Grouped as Size, Profile, Roller, Finish. Every length takes mm or inches; the model works in mm.

## Presets

- **Metal original**: 65 x 9.5 mm, 2.5 mm peak, R18 cup 1.7 deep. Thin for plastic.
- **Printed original**: Same cup with a 1.5 mm floor and soft peaks.
- **Firm hold**: Deeper 2.4 mm cup for parking on a slope.
- **Shared STL**: 76.2 x 6.35 mm, 2.26 mm crest, R7 cup 1.5 deep, square ends.
- **Light click**: 1 mm cup, long gentle ramps.

## Exports

STL and 3MF from the 3D printing panel, plus a PNG still and settings JSON.

## Files

    index.html    page shell; loads the shared kit from ../../kit/
    model.js      settings, presets and build(), the geometry engine of record (JS, manifold-3d)
    model.json    title, summary, visibility, version and changelog
    thumb.png     catalog card art

Needs a network connection: three.js loads from a CDN, as on every kit page.

## License

© Ryan Mitchell — CC BY 4.0. See [LICENSE.txt](../../LICENSE.txt).